ISO/TS 16949:2002

 

Magna-Tech Manufacturing


Environmental Sealing Technology In Locations That Support Your Production

No Change In The Appearance Or Dimensional Attributes of Your Components

 Muncie, IN  | Lincolnton, NC  | Cowpens, SC  | Sheboygan, WI  | Sylacauga, AL  | Glassport, PA  | Stoney Creek, Ontario, Canada

 Represented By :   
jobst incorporated
P.O. Box 8  Prior Lake, MN  55372
Phone: 952.447.3904  Fax:  952-447-370961

sales@jobstinc.com

http://www.jobstinc.com

  • Military
  • Marine and Underwater
  • Aerospace
    •
  • Communications
  • Recreational Vehicles
  • Trailers 
    •

Vacuum impregnation process fills and permanently seals the leak paths and voids of the part.  This process is effective, efficient and consistent; saving you the time and resources associated with failed or suspect components in the field.  

Materials                       Process                     Quality

21

Small voids and leak paths are inherent in many electronic components.  Transparent to the human eye, these microscopic voids can allow foreign materials, such as moisture, solvents, and other corrosive agents to infiltrate the component, potentially causing part failure. 
Untreated Coated Wire Cable, Submerged and 5 psi Air Pressure Applied both through wire and around jacket ID. After treating pressure tested up to 15 psi without failure

  •  Insert & Injection Mold Components
  •   Stators, Resistors
  •  Overmolded Connectors
  •   Plug Wires
  •  Vapor Management Systems
  •   Sensors
  • Wire Harnesses
  •  Terminated Connectors
  •  Thermistors
  •   Over-Mold Coil Windings
  •  Marine Outboard Motor Sensors and Components
  •   Electronic Components
  •  Sub-Assemblies
  •   Sensors
  •  Thermistors
  •   Over-Mold Coil Windings
  •  Marine Outboard Motor Sensors and Components
  •   Electronic Components
  •  Sub-Assemblies
  •   Sensors



Materials

Advanced sealing technology capabilities using standard and custom thermoset compounds.

 
  •  Flexible and Rigid Materials Available
  •   Variety of Cure Systems
  • Wire Harnesses
  •  Terminated Connectors
  •  Thermistors
  •   Over-Mold Coil Windings

back to top

Process
Vacuum Impregnation

Vacuum Pressure Infusion

 

ISO/TS 16949:2002 for Magna-Tech Manufacturing

Magna-Tech’s Quality Policy:

To effectively provide customer satisfaction through continual improvement of our processes and systems while operating the company in a manner that achieves our financial goals and enables us to provide a secure future for our employees.

All facilities currently operate under ISO/TS 16949:2002 standards.

 

 
ISO and WBENC logo

 

back to top

 

All Contents Copyright © 2010 jobst incorporated

P.O. Box 8  Prior Lake, MN  55372

Phone: 952.447.3904  Fax:  952.447.3709.6121

sales@jobstinc.com

http://www.jobstinc.com